-
Content Count
27 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout escort1300GT
-
Rank
Old Skool Member
- Birthday 25/01/1982
Contact Methods
-
MSN
evagoras_mama@hotmail.com
Profile Information
-
Gender
Male
-
Location
Cyprus
-
Interests
Cars
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
-
escort1300GT started following Escort mk1 1300GT exhaust and ESCORT MK1 brake master cylinder seals
-
Hi I want seal kit for my escort mk1 brake master cylinder. Mostly i want the seals for the reservoir. The car is an escort MK1 1300GT 1972. Can anybody tell me where can i find seal kit suitable for the master cylinder. The master cylinder is the one the picture attached. I want the seal number 5 snd 6
-
Escort MK1 brake fluid reservoir
escort1300GT replied to escort1300GT's topic in OLD SKOOL FORD CHAT
Anyone???? -
Hi Can anybody tell me where can i find escort mk1 new brake fluid reservoir or in mint condition as of the pictures?
-
Thanks for your replies
-
Thanks for the reply. I have a question. How do you measure the diameter? Internal or external?
-
Thank for the reply. I have a question. How do you measure the diameter? Internal or external?
-
Hi Can anyone tell me what is the stock exhaust system pipe diameter for escort 1300gt? What is the best upgrade for this engine
-
Hi Can anybody tell me where i can find a pair of FRONT quarterlight rubber seals (opening triangle windows) for escort mk1 2 door? thnx
-
Hi Can anybody tell me the factory front springs rate (lbs) for an escort mk1 1300GT 4 door? (mine has the reinforcement strut top plates) thnx
-
Has anybody installed a pertronix ignitor II with a new coil (12V) on an escort mk1? The ignitor has only two wires that goes to + and - of the coil. The voltage on the coil now with the ignition to ON is only 5.8V. When the engine runs the voltage is 10V Where is the ballast resistor located? What are modifications needed on the wiring of the car and will this kit have any effect on the rev counter or anything else on the car?
-
Hi Can this happened from moisture in my garage?
-
Hi My car was painted in the summer and now i noticed very very small bublles in the middle of the two doors and also on the boot lid (boot lid is new) The doors had no rust at all before restoration in that point. The car is dry stored. I wonder about the rest of the car. The paint cost me over 2000 pounds What are these bublles? Please help me
-
What have you done at last. My car was painted in the summer and now i noticed very very small bublles in the middle of the two doors and also on the boot lid (boot lid is new) The doors had no rust at all before restoration in that point. The car is dry stored. What are these bublles?
-
I dont think that this is caused from wheels or tyres because this was made with previous wheels on the same speed The car passed MOT few days ago. The guy from the MOT told me that might be little worn the inner bushes of the track control arm. Can this cause that steering wheel flickering There is no play in rack all ball joints are ok the tca were changed few years ago so i dont think that there is a bent one. I would check the inner bushes of the tca and if the rack is loose When you write tracking out what do you mean?
-
I dont think that will be incorrect wheel balancing because the same thing was made with previous wheels