Daveyboy20 Posted January 10, 2007 Author Report Posted January 10, 2007 Cheers mate, so literally any bit of water hose can be connected up to it then? Do you have to make sure the water flows the correct way through?
Mark2Mark Posted January 10, 2007 Report Posted January 10, 2007 I used the bit coming off the bottom rad hose, i don't think it matters which way the water flows as the water flows through it no matter what, it's just that as the water heats up it opens up the chokes.
Daveyboy20 Posted January 10, 2007 Author Report Posted January 10, 2007 Coming off the bottom rad hose? wouldnt that be.. i cant really visualise it i guess its totally different on an anglia. There are a few smallish piupes that go over the top of the engine to the heater - do you reckon i could use one of them?
Mark2Mark Posted January 10, 2007 Report Posted January 10, 2007 Yeah sorry did not really explain that properly the bottom rad hose has the heater pipe coming off it but yeah any hose that goes to the heater should be fine as long as it is the correct size. It's a pitty you are not in stoke still i would give you a hand.
Daveyboy20 Posted January 10, 2007 Author Report Posted January 10, 2007 Ah cool that makes sense, i was worried in case it'd be more complicated than it seems. Cheers for your help mate
Mark2Mark Posted January 10, 2007 Report Posted January 10, 2007 No problem mate, hope you get it sorted P.S Make sure you jubilee clip the pipes on VFT because there is some bloody presure in them i found out the hard way Good luck with it mate
Daveyboy20 Posted January 10, 2007 Author Report Posted January 10, 2007 Sorry probs a daft question, whats VFT? Im gonna do the job tomorrow, oh by the way - the 32/36 thats on it has apparently been jetted for a 1.6 (the cortina is 1.6) the 32/36 that im puttin on tomorrow is on my 2.1 and is jetted for a 2.0 standard, what difference do you think it'll make - will it run badly? or will it be same speed just worse MPG? Cheers mate
Daveyboy20 Posted January 10, 2007 Author Report Posted January 10, 2007 Oh, is it very King tight? at an educated guess!
Mark2Mark Posted January 10, 2007 Report Posted January 10, 2007 Yeah correct on VFT as for the jets i think it will be a case of suck it and see the 2.1 jets will be too big but how bad it will run i don't know. but if you have both carbs there just whip the top off and swap the jets it's dead easy, check they are clean while they are out too
Daveyboy20 Posted January 10, 2007 Author Report Posted January 10, 2007 Cool, cheers mate i'll no doubt give the update tomorrow night - cheers for all the advice everyone
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now