Mgentry90

Never heard of it but if sounds great. Is it the road along side the sealife centre??

Ok, so for a fast road car and hub face mounted discs you think I'd be ok?

I've seen a post somewhere on this paint issue, something like damp seeping into the top layer of paint, t cut might help. I have the same in places

Mk3 capri its for

Rear disc conversion means the spigots on my half shafts will need extending by around 10mm, does anyone know a place that could do this for me in south Essex area/top of Kent area?

Tom e cropp, got any jobs going?

Engine light on dash now, runs fine though. Got an easyobd2 set up and laptop from a mate that I once used on girlfriends mondeo, but doesn't seem to work on the fiesta. Can anybody spare some time to pop round and have a gander with their diagnosis stuff please? Being ford lovers I assume everyone has one tucked under their beds? Lol

Why park your car there crazy fools!

Bmw e30 is a common swap with some tinkering. Not sure how bulb setup is though

Chris did you buy the esc recently?

Just remove the high beam lights and extend the grill, there's a green one on eBay already done. Buy that one and be done with it

Failed attemp to kill meaning you wanted to smash it before hand?

Ill see if I can make the x mas meet

Thanks everyone, managed to find one now so don't need to borrow one. Much appreciated, will post some pics up soon of the car

I had similar to bottom, no problems

I'm going to wait till car is done before I attend meets, I'm a bit shy anyway let alone turning up without my oldskoolford!

That would be much appreciated, do you have an attachment incase I canny find mine?

No mate, when no tools are to hand any possible idea is a good idea. It was only a space saver spare thing anyway

Attempted to hit the shafts out last night before it got too dark using an old steel, apart from I now have a buckled wheel- made no difference lol. Found a slide hammer set on eBay for about £35, anybody know how bad the quality is? Or shall I be the guinea pig?

Ooh yes please I do have attachment somewhere that I made before when I had use of one.. Should be in the boot

Thanks guys that's tomorrow's job if I'm free, hope I have a steel wheel! Think I do.

Atlas axle, bolts are a blind hole

Would this work with the axle on my kitchen floor? Lol

Need to remove drive shafts from axle, anybody got a slide hammer I can use? Or any other suggestions please cheers I'm in aveley essex

Yes I'm in essex