Fitting bonnet pins ....

[Mr.Sumo]

..stupid i know , but , how the fook do you line them up to drill the holes , through the bonnet to the inner wings

 

Yes , i think i"m losing it...................

[zetecmk2]

errr,,,,,,.........long drill bit??? honestly! (sorry about attitude...wine!!)

[w p e]

masking tape on the bonnet were you want the pins mark out the position

and drill through the bonnet and just touching the slam panel or pull the drill bit out the chuck so bits longer. start with pilot then up to 10mm

[Col-ashtonmobile]

i drilled & bolted mine to the slam panel first then put some chalk on the top of the pin lower the bonnet down then where the chalk mark is drill your pilot hole from the under neath the bonnet first

[lee_capri]

i drilled & bolted mine to the slam panel first then put some chalk on the top of the pin lower the bonnet down then where the chalk mark is drill your pilot hole from the under neath the bonnet first

 

i do simaler without chalk , just get the bonnet and drop it , and it will leave 2 small dents in the bonnet ,thats the way i do it , never thought of useing chalk

[Stu_B]

i drilled & bolted mine to the slam panel first then put some chalk on the top of the pin lower the bonnet down then where the chalk mark is drill your pilot hole from the under neath the bonnet first

 

Thats how I did it but used a tiny blob of touch up paint

[Mr Sam]

i think i just shoved a drill through the lot after marking a spot that looked right

 

 

just dont get cheap ones