Stu_B Posted August 18, 2008 Report Posted August 18, 2008 I have just bought a welder so need to start cutting repair patches etc, I have an angle grinder & an air saw but these both seem over the top for working with smaller pieces of sheet metal & for cutting out smaller pieces of the car. I'm looking for something quite small, that will take small cutting dics, grinding tools etc. I guess like a dremel or something, what would everyone recomend?
Retro-gone. Posted August 18, 2008 Report Posted August 18, 2008 for repair pathes you shouldnt be really using anything that good quality gilbows wont cut, saying that i use a small air grinder cos its quicker.
Guest cortinamad-gonetoo Posted August 18, 2008 Report Posted August 18, 2008 scissors i always just use a grinder
Stu_B Posted August 18, 2008 Author Report Posted August 18, 2008 I'm using a grinder at the moment but it just seems a bit big & clumsy, I guess I need to get a decent workbench/vice setup if I'm gonna try & do a decent job of this!
emu Posted August 18, 2008 Report Posted August 18, 2008 either a decent pair of gilbows or decent aviation shears should cut pretty much anything that you need to cut repair patch wise
evil knievel Posted August 18, 2008 Report Posted August 18, 2008 either a decent pair of gilbows or decent aviation shears should cut pretty much anything that you need to cut repair patch wise including your fingers, watch out
hellblue Posted August 18, 2008 Report Posted August 18, 2008 If your using the grinder then use the realy thin cutting disc's they make a nice job of it
vibrating_Cake Posted August 19, 2008 Report Posted August 19, 2008 dremel hand tool. although the disks break easym but are cheeeeeap as hell
Stu_B Posted August 19, 2008 Author Report Posted August 19, 2008 dremel hand tool. although the disks break easym but are cheeeeeap as hell What's the chance of one embedding itself in my face? I already have enough scars there... don't fancy anymore
Gonzo Posted August 19, 2008 Report Posted August 19, 2008 Dremel disks last about 10 bloody seconds if you cut anything thicker than tin foil. Just get a 1mm cutting disk on a regular grinder, or use a decent hacksaw.
c1arke Posted August 19, 2008 Report Posted August 19, 2008 use the 1mm disk and cut to much and just weld the cuts back up
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now