oil separator

[Jiffer]

just got a bailey motorsport oil separator tank for an n/a cosworth. any ideas where the fittings go? greatly appreciated

[Jiffer]

bump

[puddy]

The two pipes side by side, one should go to the block breather already fitted, I did away with the

 

flame trap on my turbo yb setup.

 

The other one people normally fit to a fitting at the back of the cam cover, if you turn the cam

 

cover upside down you will see a mark where you can drill and fit it.

 

One of the lower ones , you can go back to the lower block with for a return, on a 200 block there

 

is a fitting on the rear of the rhs of the block you can use.

 

The other one I would fit a pipe to with a k&n breather filter above the engine.

 

 

Hope this helps.

 

puddy

[Jiffer]

cheers mate, the bigger one that comes out the bottom straight is that the breather?