2.1CORTINA Posted March 5, 2016 Report Posted March 5, 2016 DISTRIBUTER SOLD CAM COVER SOLD FLYWHEEL SOLD DIPSTICK SOLD ALTERNATOR SOLD HEAD SOLD THERMOSTAT HOUSING SOLD ENGINE SOLDSUMP SOLD Hi, I have various bits for sale, all will be dirty and used (just under 10,000miles) but perfectly functional as they were being used in my car until recently. Some parts may have a bit of surface rust or remnants of gaskets etc. I would reccommend that parts are thoroughly cleaned before fitting. All parts can be posted except I would rather have the short engine collected.Standard width head modified by "SRD" in Launceston Cornwall, gas flowed, skimmed, bronze valve guides, hardened valve seats, Kent cam kit FR30. Cost to me was over £800 so grab a bargain at £300 ONO £20 postageDrive torque stage one clutch in good condition. Cost new £133 but I can't imagine there's a lot of demand for second hand clutches so £20 ONO £8 postage.JEM built 2.1 short engine, see jem website for full spec on their engines, comes with head bolts that are shorter as the block is decked. Will also come with an "xpower engines" high pressure oil pump. Will need old gasket etc cleaning off. £300 ONO collection only.Sump, few dents and a bit of surface rust, dirty but functional. £10 + £8 postage.Fan, viscous type. £10 + £8 postage.Lifting brackets/eyes. Good cond. £5 + £5 postage.Water pump for viscous fan and thermostat housing. £5 the pair +£5 postage.Gearbox to engine sandwich plate. Has been cut as can be seen in the PIC but doesn't effect it in any way. £10 + £5 postage.Inlet manifold for twin carbs, I ran 40's on here but the openings look plenty big enough for 45's. Make is hiflo and has been repaired with welds, all looks very professional and didn't deter me buying it. £35ONO + £10 postage.
GJUK Posted March 5, 2016 Report Posted March 5, 2016 dipstick please if you can give me the length, is it ~ 260mm long tube?
2.1CORTINA Posted March 5, 2016 Author Report Posted March 5, 2016 dipstick please if you can give me the length, is it ~ 260mm long tube? Its about 313mm from one end of the tube to the other, not taking in to account the bends in the tube. From the top of the tube to the bottom of the dip stick its about 460mm. I guess if you know the dimensions your after you could easily mod this one to the correct length? PM me for the parts you want and I will send you payment details. Cheers
Recommended Posts