what primer

[GWtaylor]

finally got the garage cleared to prime parts what primer should i go for it's going to have to be spary tin

[andrewg1323]

All depends what you;re priming!

For plastic use plastic primer, for bare metal etch primer and for everything else probably regular primer

[GWtaylor]

Etch it is

[xpackken]

2k it if you got bad pin wholes , i would wait until you get a good compresser and whack it with primer . block it jobs a goodn

_________________

Ford Wiki

[GWtaylor]

is 2k the propper name

[GWtaylor]

Head propper dunn in now

 

Do I

wait until i can afford a compressor

 

OR

 

just buy a decent primer in spray tin

 

I just want to get on and get sanding to get things done

 

We need a poll lol

[flyingbanana]

buy a decent air compressor ,and then you can buy loads to use on it,which are usefull and jobs are endless ....and with 2k you need special breathing gear....you dont want to breathing that stuff in

[Tom]

depends what you're painting mate. if your careful and have patience you can get a great finish with rattle cans

[xpackken]

buy a decent air compressor ,and then you can buy loads to use on it,which are usefull and jobs are endless ....and with 2k you need special breathing gear....you dont want to breathing that stuff in

 

 

ok personaly im a tinker lol and dont wear a mask when priming as are jobs are primed outside the oven before they go in . you could do it in a well ventilated area if you must but it is better to were a mask . spray tins are crap mate you need a good high build primer (2k aka tupac )

_________________

apollo mist photos

[Tom]

again, depends on whatt you're painting

[xpackken]

again, depends on whatt you're painting

 

yeh i know what your saying mate because we get the etch primer out at least once a day for small jobs . i suppose 2k is lazy but much better way ,

_________________

Battlestar Galactica Forum

[GWtaylor]

plan on doing all the rust starting from front valance to wings and so on