Will they fit?

[bmxdave]

I want to fit twin 45's or throttle bodies or bike carbs on my pop. But i dont reckon i have the space. Have any of you fitted such a setup on a pinto 100e before and do you have pictures?

 

Have a look at my pictures below, and let me know if you think i could fit any in there without any cutting and chopping. On it now is a 38dgas.

 

 

 

 

 

[mk1mexico]

You could only try mate, but looking at the pics i would say you will be struggling with twin webers. Bike carbs sometimes seem to 'bunch up' closer together so they might be a better bet.

[V8ian]

Old skool geezer has bike carbs on his Pintoed 100e, and the 4 door yellow one with pinto has bike injection

[kevmk2]

Or maybe downdrafts would fit

[Wessie]

im sure george got his set up from bogg brothers (correct me if im wrong) i suppose it all depends on the inlet manifold you use

[DAZZA]

yes george was on bike carbs & Bogg Bros set up, seem to all go in OK

[M.Bird412E]

Your gonna have to move that bulkhead over or at least back.

 

That corner gonna catch the inlet manifold and if it doesn't it'l hit the carb!

 

Its not a hard job to trim that corner out and replate it!

[antz]

im sure george got his set up from bogg brothers (correct me if im wrong) i suppose it all depends on the inlet manifold you use

 

i seem to think they can supply you with a full kit including the carbs themselves but i might be wrong.

 

I know they do custom manifolds etc etc etc.

[Guest MK1gaz]

No they won't fit unless you have an airsaw and a hammer

[bmxdave]

Can you not get any offset manifolds? Or would that starve no4 cylinder?

 

Id go downdraughts but i dont think i have the height availible.