? for the welders

[Jiffer]

like a prat I left the gas on on my mig and have found out tonite I'm out of gas, and need to fab up a small bracket for a fuel reg.

I have got a full bottle of argon / co2 mix I used for some stainlees welding, will this do for 2mm mild steel plate?

cheers

[baz105e]

as long as its inert (non flamable) gas it will be ok for 2 mm plate you wanna turn your amps and wire speed up a little

[Jiffer]

cheers baz ,

wana get it done before I get to far into the strongbow

[Fishtailparka]

I use argon/co2 mix for all my welding. I thought most people did.

CO2 is OK, but not as good as the mix.

[mex255l]

any inert shroud gas will be fine turn up the amps and get going

[NeilT]

I use argon/co2 mix for all my welding. I thought most people did.

CO2 is OK, but not as good as the mix.

 

ill second that personaly i profer argon/co2 mix

[Mr Sam]

cheers baz ,

wana get it done before I get to far into the strongbow

 

[petrolhead]

I use argon/co2 mix for all my welding. I thought most people did.

CO2 is OK, but not as good as the mix

 

 

thirded! but just my personal opinion