Jump to content

escort21

Members
  • Posts

    2,605
  • Joined

  • Last visited

Everything posted by escort21

  1. What you need is a ignition curve that matches your engine ......phone H&H Ignition solutions
  2. And the 'aluminium mesh' shelf was sold out!!....fooking chavs..
  3. Nice thermostat housing Vista ....what lathes that?, similar to a harrison i've got at work
  4. Lots of nice blantant business plugging there Jeff ...looks good, can you not get better thermostat housings than that though...
  5. Get to machine my own car parts at work
  6. Thats right....FOOK OFF ......i will get my xmas dinner and its gonna have pork in it.....if muslims dont like that they can FOOK OFF too
  7. Either of the owners clubs do them new, they aren't cheap though, there was someone on ebay selling them for 200quid a set
  8. Well done that and its the same...think it must be a blocked fuel line/guaze in the tank maybe?
  9. Maybe it is i'll check...where is it on a cappa?
  10. When i fill my capris fuel tank to the brim i have to advance the timing by 3-4 degrees because it runs crap and when the tank gets to half full i have to move it back again cause it runs crap...WHY??!!....any ideas??
  11. And faster??!!
  12. Used my choke on my single 40 for 2 years....told you it worked
  13. Early xflows had them and the pistons had no valve cutouts....why?....i dunno! but some engine tuners put small chambers in the head so they can run flat top pistons which have less mass above the piston gudgeon pin which makes the rev up quicker Most use the flat head and 1300 pisons to raise the compression ratio as it works and its cheaper ....just ask Fiestasteve
  14. Dunno...look in the haynes lie manual....erm 22-25 at a guess
  15. Less choke = running lean = gets hot quickly..
  16. Hmm...
  17. Which is why the M16 pads don't fit...
  18. Those alloy top nuts are fooking shit....i got some steel ones when i had problems on a past car. Make sure the threads are dead clean or it'll fook the alloy thread
  19. They do look like P14s Ian, will be imperial threads then Rick which means you'll have to get some imperial pipe connections, be easier to get escort ones matey
  20. Hmm ok i actually like that
  21. ermmmm....ok....hooray
  22. Seen that before on buysell ..nice car
  23. Put loads on and when it goes together what it don't want squeezes out
×
×
  • Create New...