Jump to content

Recommended Posts

Posted

rally design ones too be precise.... are they worth it? do they fit well? would i be better spending my money else where? i know they need the old lower spring mount cutting off and the tube welding over the top but is it as easy as that... commence arguments.... NOW

Posted

I'm listening...

Trying to decide where to get the kit from is the hardest part!

Mind you, I'll probably get mine from Grp4 fabrications or montgomery motorsport to save P&P but also because grp4fabrications make really good quality stuff!

Posted

I had/done them on my Cortina,You have to take the insert out to stop damaging it whist welding,

And it work fine for me... well worth it,

Make sure you buy the front threaded tubes as a friend of mine weled the smaller rear tube on the front.....

But well worth the money...

Saying that GAZ coilovers are much better . . .

As they are fully adjustable and you can change the re-bound as well as the height :wink:

Posted

so they just slide striaght over the old tube? dont need too make up adapters or anything then?

Posted

I've got them on my Capri... work great, wouldn't go back to regular springs now.

 

225lb springs wound down on new Billies, quite tight but probably try some stiffer ones soon.

Posted

Will take an afternoon to do, its certainly not rocket science, Raldes kit is about the best value for money, but there are other kist that are better quality, meaning cad plated tubes and fully machined retainers, cant remember who does them, :oops: but they obviously cost more,

If you use koni or spax RS2000 top adjustable shocks as well, makes life so much easier.

Posted

I've got a kit from Yukspeed that I'm thinking of fitting to a pair of Gp4 Bilsteins. They come with threaded tubes, bottom locking rings & spring cup for the top.

 

You'll need some springs to match too.

 

I'm in two minds on carving up these struts as they're pukka historic tarmac bodies & it seems criminal to chop them about.

 

Easy to do if you have access to a grinder & welder,

 

Remove the spring (with care, don't just undo the top nut - you'll lose your teeth or worse) -

Remove the insert,

Grind off the welds that hold the old platform on

Clean off the rest of the welds off around the platform area

Slide on the coilover thread, I think 2" was the distance from the top of the strut body (might want to double check this) - also depends on the spring length you choose.

Weld the top & bottom of the tube in place, don't go mad though, 4 decent welds of 15mm will do.

Seal any gaps & paint

"Refitting is the reverse of removal"...

 

One tip, don't adjust the ride height with the weight of the car on the springs - it'll ruin the alloy rings in no time flat.

Posted

My buddy's got 2 pairs of rare grp1 struts, seriously thick insert! He's converted one of them to coilovers, and done a really neat job! He wouldn't go back to standard if he had the choice! :wink::thumbsup:

 

I think it's a worthy conversion to do on your OSF, especially because it allows you to slam it to the ground :ykt:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...