is it possible.....

[antz]

is it possible to convert a normal pedal box into a bias one?

 

how is it one, how much does it cost and do you need to have any special skills?

 

thank yar!

[slimrs]

they can be converted mate, im sure classic ford showed you how to do it in one of there issues. dont know how easy it is

[antz]

they can be converted mate, im sure classic ford showed you how to do it in one of there issues. dont know how easy it is

 

cheers slim ill have to get in the loft and have a look through bout 3 years worth of mags to find it

[Jay_harrier]

yep, they can be converted - steel plate, master cylinders, bias bar & adjuster and you're away.

 

I think the MK2 prep book covers it.

[antz]

why didnt i look in the prep book? dumbass its sat in front of me!

 

slim you are right...august 2005 of cf mag

 

cheers everyone. ill look into it.

 

where can i get the parts to make one?...(other than a pdal box of course)

[emu]

I think Yukspeed used to do the pre-cut plate ready to be welded on. Not sure if they still do though.

[antz]

I think Yukspeed used to do the pre-cut plate ready to be welded on. Not sure if they still do though.

 

are they the ones based near york?..if so thats only about an hours drive...might have to make a day out

 

cheers emu ill look into it

[emu]

http://www.yukspeed.com/special-offers.htm

 

Very briefly mentioned here,about quarter of the way down.

 

They are in North Yorkshire somewhere.

[mk14dr]

Yuks' just off the A64 at the Castle Howard turn off ( the one that goes past the monument)

[antz]

Yuks' just off the A64 at the Castle Howard turn off ( the one that goes past the monument)

 

 

its less than an hours drive frm me then!!!.....might have to go see him after get back from my hols