xflow dip stick sleeve

[flyingbanana]

if some one could measure how much the metal sleeve pokes out from the hole i would be great full,has mine is no long there and need to know how far it sticks out from the block....thanks

[bomber1]

will look in the morning tho its 2cm from memory

[johnny_h]

dead on Jason, just measured 20mm

[bomber1]

dead on Jason, just measured 20mm

 

that was a guess best be getting a tight anorak for crimbo

[flyingbanana]

so 20mm sticking out....do you know the overall length of it ,prob dont matter has long has its sticking out the right amount....cheers lads

[James HPE Motorsport]

it doesnt actually matter how long this tube is and if you really wanted, you could run it without as there is a stop on the dipstick itself which judges how far the dipstick goes into the sump. So even if your tube is only 10mm long (I have just got a rubber tube about this length on mine to stop oil seeping out) you will still get the correct reading!!!

[Toby]

Ok I know this will get me a prize for the most boring post but.....

 

I had 2 dip sticks with the same part no. which were diferent lengths form the lump down!!??!!

 

It's true

 

But dull!

[johnny_h]

Precision engineering eh?!