Jump to content

Recommended Posts

Posted

After my lads slight diversion into the Armco barrier at cadwell a while ago finally got nibbling at the Anglia. On first impressions only front wing and front panel damage. On further investigation chassis bent in two places, door frame out of shape and suspension further back than intended. So out with the plumb lines tape measure and two ten ton porta power kits. So far cut the front off to reveal the extent of inner wing damage, not a lot really, nowt what a good pulling a beating didn't cure ! My panel beating skills are just below nil ! So off with the front to put on a flat surface to take the dents and squashed metal back into some form of shape. Then to check the chassis alignment , found to be 20mm up at the front so out with the porta power, sorted back level and square again. Investigation into the slight kinks in chassis showed the suspension had taken a good knock aswell.  Being mounted on compression struts this is what had caused the chassis kink. Drop lines and tape out showed the leg had moved 14mm backwards. Out with the trusty angle grinder and cut the mounts off, if I'd have used the poxy original mounts it would have ripped it off the chassis. But me liking things to stay where I put them modded the mounts and used 2x 1-1/2 thick wall box which is what caused the chassis problem. On saying that you could have adjusted the compression strut and kept on driving the car. To put stregthening back in the chassis I've used 2mm steel either side of chassis where the kinks where. That ain't gonna move again. Door opening sorted, just waiting for a headlamp repair panel to arrive to try and restore the wing to its former glory. Then it's the dreaded....FILLER! ....I hate filling ! Then hopefully back to the track for round 2/3/4/5/ and six without detours this time...lol......But that's life. You don't know the limits till you've passed them then it's pick up the pieces and move on.

image.jpeg

image.jpeg

image.jpeg

image.jpeg

image.jpeg

  • Like 1
Posted
36 minutes ago, nosher 64 said:

Nice job Col... The rest will buff out !!

Hope the lad was ok ??

Yes thanks Steve, like all young uns. Sorry Dad, when will be mended for another go !! No mention of ill come and give you a hand !

  • Like 1
Posted
13 minutes ago, khanlad said:

With all that cutting out and hammering, are you going to make it look like an escort? 

Do you mean full of rust and cheap Chinese panels ? Don't think so ! Still going to be an iconic Anglebox....lol

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...