Mk1 Tina accelerator pedal problems

[chinkamon]

Hi all
Lookin at fitting twin carbs on my mk1 however it's rod controlled on the existing carb, the twin carbs are cable set up, what's the easiest way to convert the old to new set up? Any thoughts? 
Thanks in advance 

[mk1del]

Would have thought if you make the hole smaller in bulkhead to accommodate cable  and drill and slot  pedal

[colr6]

You will have to weld a rod on the cross shaft of the pedal approx 100mm long. Cable then would go through bulkhead and use poss mk1/2 escort throttle cable. Other alternative is poss swop cortina throttle pedal for an escort one if the shaft is long enough to go through pedal box and again use escort cable.

[nosher 64]

Just like Col we welded a rod to the accelerator pedal and fitted a sytec throttle cable block to it.. Simples..

[Kenbex522]

I did mine like this to give you an idea. I chopped the original end off. The photo is taken at mock up stage and was welded properly with a gussest

[chinkamon]

Thank you for your help guys