davreeve Posted October 25, 2007 Report Posted October 25, 2007 A few years ago i bought a MK1 mex ,drove it for about a fortnite before the steering went completely.Someone had converted a short stem rack to a long stem one by badly tack welding the extra piece to the rack!It snapped off fortuanatly at low speed. What are the most suspect or dangerous repairs you lot have come across on old fords you,ve bought?
antz Posted October 25, 2007 Report Posted October 25, 2007 only a little thing but the lady told me the battery goes dead after 2 days and you have to jump it.....no acid in the battery my dad had a mk2 cortina crayford with patches welded on patches welded on patches and somehow when you started it with the clutch out itd try to rip itself apart from the inside outwards
Posse Posted October 25, 2007 Report Posted October 25, 2007 I brought a mk1 escort a few years ago and someone had done the new strut tops in tin (backed bean tin i think) and a repair on one one of the seals with it
escortmad79 Posted October 25, 2007 Report Posted October 25, 2007 The welding on Michelles Mk1 when she got it!! By the guys admission, he couldn't weld for sh*t but had a go! Luckily her Dad's sorting it out!
james p Posted October 25, 2007 Report Posted October 25, 2007 mk2 escort the strut tops were rotting throu so they painted em in undrseal as a repair
beedz Posted October 25, 2007 Report Posted October 25, 2007 mk2 fiesta - the section where the sills meet the rear part of the door frame - both sides were made completely out of plastic bags and filler. lasted a year of driving until the area around it started to rust & i investigated. bloody thing would've folded in half in a crash twats did a brilliant job hiding it though-matched the curves and little recesses perfectly, would've taken longer to do it than welding!!
c1arke Posted October 25, 2007 Report Posted October 25, 2007 dad bout a mk 4 (i think) tranny and the chassis rails were so bad when he drove it home the cap biped forward
Nettles Posted October 25, 2007 Report Posted October 25, 2007 A few years ago a friend of mine brought a MK3 Escort. It was a nice clean looking motor but something didn’t look quite right. It was only when he happen to park it next to another MK3 Escort that we noticed it was a good 4 inches longer. Decided to have a closer look and discovered it was a cut and shut job!
Cookie Posted October 26, 2007 Report Posted October 26, 2007 it was a good 4 inches longer. Just goes to show what thick morons these car thieves are, for fooks sake
Mk 1 Mark Posted October 26, 2007 Report Posted October 26, 2007 Even dealers dont have a clue,In the late 90`s in East london there was a mk4 rs turbo for sale £5999 And it had on the advert cosworth powered...Thought mmmm RWD Cosworth it was in a petrol station that had a car sales place went there and asked about it,Has it got a cosworth engine in it...Oh yes was the reply,Looked @ the Rear Standard Mk4 escort...Oh well Cosworth FWD then Pulled the bonnet stanart Rs turbo engine,Looking puzzled i said i though you said it had a cosworth engine in it? He replied It has? It was built by a man who worked for cosworth? But its an Rs turbo engine i said? Oh well but is cosworth powered and built?...Err yeah ok mate .... thing was up for sale for at least 6 months untill the garaged moved.. As for repairs,Got an even funnier one,Was selling my Old mk1 Red Mexico in the 80`s as i had bought an harrier, Bloke came over and the shell was tired but the engine was strong and it went well,Took him for a drive giving it large flat out in 3rd in Goswell rd heading towards the Angel islington, And it joins from city road and a bus pulled out and i hit it at at least 40 mph..... Ripped the front clean of,it had paper in the inner wings from 1976 and quailty street tin cut out on top off of the legs/inner wings.... Ooops bloke never bought the car.... Quality steet made for sharing...but not on a mk1!!!!
w p e Posted October 26, 2007 Report Posted October 26, 2007 Even dealers dont have a clue,In the late 90`s in East london there was a mk4 rs turbo for sale £5999And it had on the advert cosworth powered...Thought mmmm RWD Cosworth it was in a petrol station that had a car sales place went there and asked about it,Has it got a cosworth engine in it...Oh yes was the reply,Looked @ the Rear Standard Mk4 escort...Oh well Cosworth FWD then Pulled the bonnet stanart Rs turbo engine,Looking puzzled i said i though you said it had a cosworth engine in it? He replied It has? It was built by a man who worked for cosworth? But its an Rs turbo engine i said? Oh well but is cosworth powered and built?...Err yeah ok mate .... thing was up for sale for at least 6 months untill the garaged moved.. As for repairs,Got an even funnier one,Was selling my Old mk1 Red Mexico in the 80`s as i had bought an harrier, Bloke came over and the shell was tired but the engine was strong and it went well,Took him for a drive giving it large flat out in 3rd in Goswell rd heading towards the Angel islington, And it joins from city road and a bus pulled out and i hit it at at least 40 mph..... Ripped the front clean of,it had paper in the inner wings from 1976 and quailty street tin cut out on top off of the legs/inner wings.... Ooops bloke never bought the car.... Quality steet made for sharing...but not on a mk1!!!! paper in the inner wings from 1976. thats were i left me paper dont spose you still got it as i never finished the cross word ps goswell roads a 30mph limit
mossy Posted October 26, 2007 Report Posted October 26, 2007 filler everywhere! over paint, over dents, over holes and over rust!
Mk 1 Mark Posted October 26, 2007 Report Posted October 26, 2007 Even dealers dont have a clue,In the late 90`s in East london there was a mk4 rs turbo for sale £5999And it had on the advert cosworth powered...Thought mmmm RWD Cosworth it was in a petrol station that had a car sales place went there and asked about it,Has it got a cosworth engine in it...Oh yes was the reply,Looked @ the Rear Standard Mk4 escort...Oh well Cosworth FWD then Pulled the bonnet stanart Rs turbo engine,Looking puzzled i said i though you said it had a cosworth engine in it? He replied It has? It was built by a man who worked for cosworth? But its an Rs turbo engine i said? Oh well but is cosworth powered and built?...Err yeah ok mate .... thing was up for sale for at least 6 months untill the garaged moved.. As for repairs,Got an even funnier one,Was selling my Old mk1 Red Mexico in the 80`s as i had bought an harrier, Bloke came over and the shell was tired but the engine was strong and it went well,Took him for a drive giving it large flat out in 3rd in Goswell rd heading towards the Angel islington, And it joins from city road and a bus pulled out and i hit it at at least 40 mph..... Ripped the front clean of,it had paper in the inner wings from 1976 and quailty street tin cut out on top off of the legs/inner wings.... Ooops bloke never bought the car.... Quality steet made for sharing...but not on a mk1!!!! paper in the inner wings from 1976. thats were i left me paper dont spose you still got it as i never finished the cross word ps goswell roads a 30mph limit Old clocks always read 10 mph faster
johnny_h Posted October 26, 2007 Report Posted October 26, 2007 A while back I bought some fibreglass from affordable classics and when I got it home, after a good look I realised it had the remains of a MK1 Escort attached to it. o_O
Twinkle Posted October 26, 2007 Report Posted October 26, 2007 A while back I bought some fibreglass from affordable classics and when I got it home, after a good look I realised it had the remains of a MK1 Escort attached to it. o_O dont i know it has lots more metal in it now
X FLOW EDDY Posted October 26, 2007 Report Posted October 26, 2007 Not a ford but a mate of mine bought a nissan sunny coupe a few years back and said to me that the seat needed looking at cus it had droped one side when i had a look underneath it the seat was bolted to a peice of plywood that was whare the floor pan should have been !! It could have killed him if the wood gave way while he was driveing it, it was held in to the car with bent nails hooked thru drilled holes in the tunnel that ran down the middle of the car and just sat on the sill the outher side. And it had a full 12 month mot when he bought it . Needless to say that garrage was shut down after a visit from the MOT licence people !!!!!!!!!!!!!!!!!
over_head_cam Posted October 26, 2007 Report Posted October 26, 2007 I pulled a lump of filler about the size of a bag of sugar out of the sill of my cortina
martymk1 Posted October 26, 2007 Report Posted October 26, 2007 reminds me of my first car in 1978, mk1 escort 2door, ex panda car, bought it off my then to be brother in law, two weeks later found out the floor was made of plastic padding, quickly gave it back to him
razersedge Posted October 26, 2007 Report Posted October 26, 2007 one of me mates bought an rs cheepish got it home decided to strip it down and redo anything that wasn't quite right cos he found there was a plate that was fiber glassed in not welded after a week of ripping plates off he could check the depth of the front tyres from the back seat and the rear wings and rear panal moved 5 inches to each side cos they wern't attached to the boot floor needless top say it no longer with us bit of a shame though
Muttley MK2 Posted October 26, 2007 Report Posted October 26, 2007 Not ford i'm afraid but some years back I had a 1971 bullnose firebird formula 400. If you hit the brakes hard the offside caliper would sieze on and you would have to get out, poke a screwdriver through the wheel and lever the pads out. I got pissed off with this and took the caliper off to recon it. I clamped off the brake pipe and put the wheel back on. Time passed and I was driving around being very careful with the brakes. Well my then missus had a hissy fit one day and got a guy to clear the patio it all went including my caliper!! I was pissed off as I wanted to sell the car so I decided to sell as was. The first guy to come was about 19 and really uninformed about muscle cars, I warned him that the brakes needed carefull application and off we went round the block. Well he got to the first junction and wellied it off to the right, being a manual with about 350 horses it broke loose and veered off to the right, he hit the brakes HARD and it promptly turned left, mounted the pavement and wiped out some dustbins and ten feet of hedge!!! When we came to a halt he looked at me and said "F*&k me this thing is hard to control" Thing is he bought it, he didnt chip me on the price and he NEVER came back, weird or what!!!!
tazrocks88 Posted October 27, 2007 Report Posted October 27, 2007 my sisters boy friends escort van had the sills fixed on with sicaflex
Toby Posted October 27, 2007 Report Posted October 27, 2007 Not ford i'm afraid but some years back I had a 1971 bullnose firebird formula 400. If you hit the brakes hard the offside caliper would sieze on and you would have to get out, poke a screwdriver through the wheel and lever the pads out. I got pissed off with this and took the caliper off to recon it. I clamped off the brake pipe and put the wheel back on. Time passed and I was driving around being very careful with the brakes. Well my then missus had a hissy fit one day and got a guy to clear the patio it all went including my caliper!! I was pissed off as I wanted to sell the car so I decided to sell as was. The first guy to come was about 19 and really uninformed about muscle cars, I warned him that the brakes needed carefull application and off we went round the block. Well he got to the first junction and wellied it off to the right, being a manual with about 350 horses it broke loose and veered off to the right, he hit the brakes HARD and it promptly turned left, mounted the pavement and wiped out some dustbins and ten feet of hedge!!! When we came to a halt he looked at me and said "F*&k me this thing is hard to control" Thing is he bought it, he didnt chip me on the price and he NEVER came back, weird or what!!!! Lol - he didn't really leave his options open!!
Toby Posted October 27, 2007 Report Posted October 27, 2007 When I originally bought the Cortina the bloke I bought it off was very insistant that nothing had been bodged on it. However, whilst driving in the dark, the first time it rained since ownig it, when I switched the wipers on each of them kind of went a different speeds, hit one another and fell off! They were held on by sellotape wrapped around the gnurled driving thingamy. So there you have it....that's not a bodge
bortaf Posted October 27, 2007 Report Posted October 27, 2007 Cortina Mk4 i bought had a fiberglass chassis rail, right where the back axle bolted on , ripped out one night, the axle went back and pulled the handbrake on i had to reverse 4 miles home Or the land rover SWB i brought from an auction, was stuck in low range 4wd (not that i knew anything about LR's), got to 50 on the way home and the axle wind up snapped the chassis in half did the last mile like a clown car, up and down, up and down, roof bukling merryly away Had to climb out the back door cos i couldn't open the doors
Toby Posted October 27, 2007 Report Posted October 27, 2007 Cortina Mk4 i bought had a fiberglass chassis rail, right where the back axle bolted on , ripped out one night, the axle went back and pulled the handbrake on i had to reverse 4 miles home Or the land rover SWB i brought from an auction, was stuck in low range 4wd (not that i knew anything about LR's), got to 50 on the way home and the axle wind up snapped the chassis in half did the last mile like a clown car, up and down, up and down, roof bukling merryly away Had to climb out the back door cos i couldn't open the doors Now that's a bodge!
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now